| Collection: |
Defense Finish Collection |
| Nominal total thickness: .045 ± .005
inches (45 ± 5 mils)
Standard weight: 34.00 ± 2.25 ounces per linear yard
Abrasion resistance: No significant wear after 200,000 double
rubs with #8 cotton duck using the Wyzenbeek test method
-25° F cold crack resistance
Anti-static finish
Sulfide stain resistant
Oil resistant
Width: 54 inches
Roll length: 40 yards
Go to Top
|
Port Authorities of New York and New Jersey
CID-A-A-2950-A (Formerly CCC-A-680a)
Federal Standard 191A Test Method 5903.1
Federal Specification CCC-A-70OJ
FAA Regulation 25.853 (a) and Appendix F, Part 1 (a) (l) (ii)
FMVSS 302
California Flammability Regulation (Bulletin 117, Section E)
BIFMA Class A
UFAC Class 1
Go to Top |
| Care and Cleaning Instructions: |
It is recommended that each stain is cleaned
in a stepwise manner using the sequence below.
Step 1: Regular cleaning (dirt and grime): Use mild soap and
water, then fresh water rinse.
Cleaning frequency depends on use. As a minimum, please clean
weekly.
Step 2: Stubborn stains (crayon, eye shadow, chocolate, blood):
Wipe using a soft cloth or
soft brush. Use detergent cleaners such as Formula 409 or
Fantastik. Rinse with dean water
and wipe dry.
Step 3:** More difficult stains (ballpoint pen, lipstick,
mustard, tar or asphalt): Carefully
clean the stained area with lighter fluid or rubbing alcohol.
Carefully rinse with clean
water and dry. Note: For best results, immediate attention
is required for severe stains.
**Caution: Exercise care as these solvents are flammable.
Use only small quantities of solvents and keep clear of any
sources of ignition. Wear protective gloves and ensure cleaning
takes place, in a well ventilated area.
Go to Top
|
Automotive Seating and Trim
Conference Room Seating
Executive Seating
General Office Seating
Hotel/Motel Room Seating
Home Office Seating
Foyer and Lounge Seating
Residential Seating
RV Seating and Trim
Work Station Seating
|